普通全钢冲模的冲压精度分析外文翻译

普通全钢冲模的冲压精度分析外文翻译(中文+英文共5000字)
板料冲压件的精度准确显示出其冲模的冲压精度。而任何冲件的线性尺寸精度与形位精度主要取决于冲模冲裁和立体成形冲压件展开平毛坯的落料精度。因此，多工步复合冲压的单工位复合模、多工位连续模的冲压精度，在普通冲压的众多种类与不同结构的冲模中，最具典型性和代表性。
冲模的冲压精度分析
对冲模投产至失效报废各个时期冲件的实际误差分析，可以看出其增大的时期及趋向，从而分析其增大的因素。新冲模投产至第一次刃磨前冲制冲件的误差即所谓的初始误差；冲模经过20次左右刃磨至失效报废前冲制的冲件误差称之为常规误差；而冲模失效报废前冲制的最后一批合格冲件的允许最大误差称之为极限误差。在现场，确定冲模刃磨寿命的依据是冲件冲孔与落料的毛刺高度。由于任何成形件都具有冲裁作业（毛坯落料或冲孔），对于复合模尤为如此。所以，冲件毛刺高度的触模检查和测量并按企业标准或JB4129-85《冲压件毛刺高度》对照检测就显得十分重要。

General all-steel punching die’s punching accuracy
Accuracy of panel punching part is display the press accuracy of the die exactly. But the accuracy of any punching parts’ linear dimension and positional accuracy almost depend on the blanking and blanking accuracy,. So that the compound mould of compound punching’s accuracy, is typicalness and representation in the majority. [资料来源：https://www.doc163.com]
Analyse of the die’s accuracy
For the analyse of pracyicable inaccuracy during production of dies to inactivation, we could get the tendency when it is augmentation in most time. From this we could analyse the elements. When the new punch dies pt into production to the first cutter grinding, the inaccuracy produced called initial error; if the die grinding more than twenty times, until it’s discard, the inaccuracy called conventional error; and before the dies discard, the largest error of the last batch permit, called limiting error. at job site, the evidence to confirm life of sharpening is the higher of the blanking, punched hole or punched parts. Because all finished parts had been blanked ,so it is especially for the compound dies. Therefore, the analyse of burr and measurement is especially important when do them as enterprise standardization or checked with <<the height of punching part>>. [资料来源：http://www.doc163.com]