某啤酒厂4000吨污水处理工程设计(含CAD图)

某啤酒厂4000吨污水处理工程设计(含CAD图)(任务书,开题报告,外文翻译,论文计算书10000字,CAD图5张)
摘 要
本文对啤酒厂废水处理工艺进行了初步设计。啤酒废水水质的主要特点是含有大量的有机物,属中高浓度有机废水,其生化需氧量较大,不经处理会对环境造成巨大污染。要求处理后的排放水达到园区接管标准,即:BOD≤20mg/ L,COD≤100mg/ L,SS≤70mg/ L。经分析知该酒厂处理水水质属易生物降解又无明显毒性的废水,因此可采用两级生物处理方法以使出水水质达标。一级处理主要采用物理法,用来去除污水中的悬浮物质和无机物。二级处理主要采用厌氧—好氧结合的生物处理方法,即升流式厌氧污泥床(UASB)和循环式活性污泥系统(CASS)。该结合工艺可有效去除污水中的BOD、COD。工艺流程设计为:啤酒废水→格栅→斜板沉淀池→UASB反应器→CASS池→出水。整个工艺具有投资省,处理效果好,占地面积小,能耗少的优点,此外,还在处理过程中回收了酒糟和沼气,创造了一定经济价值。
关键词:啤酒废水处理 中高浓度有机废水 UASB法 CASS法
Tian Dao brewery’s 4000 ton wastewater treatment design [来源:http://www.doc163.com]
Abstract
The paper aims to make an engineering design dealing with wastewater from beer industry. The main distinguishing feature of beer wastewater is that it contains massive organism, belonging to the moderate and high concentration organic wastewater, and requires large sum of biochemical oxygen demand. If not treated properly, it would cause great pollution to the environment. It is requested that the water must be strictly treated to meet the industrial park pipe connection standard, which is as following: BOD≤30mg/ L, COD≤100mg/ L, SS≤70mg/ L. After the analysis, it is found that the brewery wastewater belongs to the wastewater which can be biodegraded readily and have few poison, Accordingly, two levels of biological treatments can be adopted to ensure the drained water to meet the designated standard. First level of processing mainly uses the physical methods, which removes the suspended matter and the inorganic substance in the sewage. Second levels of processing mainly uses the anaerobic-aerobic biology methods, namely UASB and CASS, which can remove BOD5&COD effectively. The main processes are: Beer wastewater → bar screen → inclined board sedimentation basin→ UASB → CASS → drainage water. The entire treatment process has the characteristics of low investment, good treatment result, small occupation area and low energy consumption. Besides, economic benefit can be gained due to the collection of beer lees and methane during the process.
[来源:http://Doc163.com]
Key Words: Beer Wastewater Treatment; Moderate and High Concentration of Organic Wastewater; UASB; CASS
工程概况
该啤酒厂位于安徽滁州,目前年产啤酒8万吨,后期扩建后为12万吨,该啤酒厂废水排放规律是:正常情况下,8:00—16:00徘水量较大,其余时间较小(0:00一7:00最低),水质随废水量变化。水量大时(如洗罐水)污染物浓度高,反之则低。包装车间用碱浓清洗玻璃瓶,每周更换一次,排出的浓碱液使pH值偏高。目前,该厂废水总排放量约3000m3/d,要求本次工程按照4000m3/d设计。
拟建厂区为图中红框内,污水地面高度黄海高程40.40m,污水进水渠水渠底距离地面高度1.50m,水渠水位0.6-1.0m,园区污水厂管网管底标高为-2.4m.污水从原污水渠截留进入污水站,进行有效的污水处理,达标后进入园区管网接口,进入园区污水处理厂。
原水水质及出水要求
废水种类 来源 废水量(部分废水/总废水)/% COD/mg•L-1 高低浓度废水COD/mg•L-1 总排放口COD/mg•L-1 总排放口BOD/mg•L-1 总排放口SS/mg•L-1
原水水质 高浓度有机废水 麦槽水、糖化车间刷锅水等 5-10 20000-40000 4000-6000 1000-1500 600-800 400-600
发酵车间前酵罐、后酵罐洗涤水、洗酵母水等 20-25 2000-3000
低浓度有机废水 制麦车间浸麦水、刷锅水、冲洗水等 20-25 300-400 300-700
灌装车间酒桶酒瓶洗涤水、洗棉水等 30-40 500-800
冷却水以及其他 各种冷凝水、冷却水、杂菌水等 无污染物 <100 [版权所有:http://DOC163.com]
排放标准 100 20 70
[资料来源:Doc163.com]





[资料来源:http://doc163.com]
目录
第一章 工程概况 1
第二章 工艺流程设计 3
第三章 污水处理构筑物计算 4
一、格栅 4
1.1设计说明 4
1.2设计流量 4
1.3选型 4
1.4每日产渣量 4
二、进水渠 5
2.1 设计说明 5
2.2设计计算 5
三、调节池 5
3.1设计说明 5
3.2池体计算 5
3.3搅拌设备 6
3.4提升设备 6
四、初沉池 6
4.1设计说明 6
4.2设计参数 7
4.3池体设计 7
4.4排泥系统 8
4.5酒糟处理 9
五、中间池 9
5.1设计说明 9
5.2池体设计 9
5.3提升设备 9
六、配水井 10
6.1设计说明 10
6.2池体设计 10
七、升流式厌氧污泥床UASB 11
7.1设计说明 11
7.2设计参数 11
7.3池体设计 11
7.4布水系统 15
7.5出水系统 16
7.6排泥系统 16
7.7沼气收集系统 17
八、CASS反应池 18
8.1设计说明 18
8.2设计参数 19
8.3运行周期 19
8.4运行方式 19
8.5反应池液位设计 20
8.6池体设计 20
8.7进水及滗水装备 21
8.8排泥及污泥回流系统 21
8.9曝气系统 22
九、计量槽 26
9.1巴氏计量槽 26
9.2出水水质检验 26
第四章 污泥处理构筑物计算 28 [资料来源:www.doc163.com]
十、污泥浓缩池 28
10.1设计说明 28
10.2设计参数 28
10.3池体设计 28
10.4浓缩后污泥量 29
10.5浓缩机选型 29
十一、贮泥池 29
11.1设计说明 29
11.2池体设计 29
11.3搅拌设备 30
十二、脱水间 30
12.1设计说明 30
12.2脱水后污泥量 30
12.3压滤机选型 31
12.4螺杆泵选型 31
12.5药剂投配量 31
12.6附属设备、设施 32
12.7脱水间尺寸布置 32
第五章 污水处理厂平面布置 33
十三、布置原则 33
十四、管线布置 33
14.1污水管线 33
14.2污泥管线 33
14.3沼气管线 34
14.4给水管线 34
14.5排水管线 34
14.6雨水管线 34
14.7电线、电缆管线 34
第六章 水厂构筑物高程布置 35
十五、污水处理构筑物高程布置 35
15.1污水处理构筑物水头损失 35
15.2污水管(渠)水头损失计算 35
15.3高程设计 36
十六、污泥处理构筑物高程布置 36
16.1污泥管道水头损失计算 36
16.2污泥处理构筑物水头损失 37
16.3高程设计 37
第七章 工程投资概算 38
十七、直接费用 38
17.1设备费用 38
17.2土建费用 38
17.3其他费用 39
17.4直接费用汇总 39
十八、间接费用 39
十九、税金 39
二十、总投资 39
参考文献 40 [资料来源:http://doc163.com]